Audi A5 S5 8F 8T Rear Tail Light Lamp Wiring Plug Right O/S Outer 8T0945096

Audi A5 S5 8F 8T Rear Tail Light Lamp Wiring Plug Right O/S Outer is an original lighting installation component designed for the right, outer tail light in Audi A5 and S5 8F/8T series models. Thanks to the factory connector geometry and proper wire routing, it ensures a stable electrical connection and correct operation of the position and brake lights. It is a practical solution for post-collision repairs, lamp replacement, or damage to the factory wiring harness.

Specifications and technical data

• SKU: 8T0945096F-2
• Mark: Audi
• Condition: Used
• OEM Part Number: 8T0945096F
• Substitutable numbers: 8T0945096F, 8T0 945 096 F
• Location on the vehicle: Rear, Right
• Category: Rear Light Assemblies

Purpose and vehicle placement

The presented wiring plug is dedicated to installation in the rear part of the vehicle, on the right side, in the outer tail light assembly. It is responsible for the electrical connection between the lighting module and the vehicle's wiring, which is crucial for the proper operation of tail lights and brake lights. Using the correct connector eliminates the risk of loose contacts, flickering bulbs, or errors in the lighting control system.

Construction and technical function

The component is a section of the electrical wiring harness with a factory plug matched to the tail light socket. The design provided by the vehicle manufacturer ensures:

• proper wire routing within the bodywork,
• adequate protection of contacts against disconnection during operation,
• compatibility with the original tail light on the right side.

As a result, the installation is orderly, and the electrical connection remains stable under typical suspension and bodywork operating conditions.

Application in the lighting system

The wiring plug works with the outer tail light, supporting the circuits responsible for the vehicle's light signaling. A correctly selected component allows maintaining the consistency of the installation with the factory Audi schematic, which is important for both safety and compliance with diagnostic requirements. Replacing a damaged connector with an original wiring harness helps eliminate problems such as:

• intermittent lighting failures on the right rear side,
• overheating or melting in the area of non-original connections,
• lighting error messages in the onboard system.

Condition and benefits of using a used part

The offered item comes from disassembly and is classified as a used part, which represents a reasonable compromise between repair costs and maintaining the manufacturer's original specifications. In practice, this means:

• retaining the factory connector type and wire cross-section,
• better fitment than many universal replacements,
• the possibility of an economical repair of the lighting installation after mechanical or thermal damage.

Before installation, it is recommended to perform a standard inspection of the insulation and contacts, and then make the connections according to the service procedures for the specific Audi model.

Support for Audi lighting upgrades and repairs

If you are planning a comprehensive repair or upgrade of the rear lighting zone in your Audi and need other components from the same group, such as tail light assemblies, control modules, or additional wiring harnesses, check the available parts in the Audi tail lights and brake lights category.

For major body and lighting installation repairs, it is also worth checking out practical tips on selecting parts from disassembly – you will find them in the article Bodywork and chassis – post-collision repairs using parts from disassembly, which discusses the approach to post-collision repairs, the selection of used OEM components, and example service procedures.