Skoda Octavia Mk2 Rear Door Wiring Harness Cable Right O/S 1Z0971161G

Skoda Octavia Mk2 Rear Door Wiring Harness Cable Right O/S is an original electrical system component from the Wires, harnesses and connectors group, designed for the right rear door assembly. It ensures a stable electrical connection between the door and the vehicle body, which translates into reliable operation of all electrical components in this area.

Specifications and technical data

• SKU: 1Z0971161G
• Mark: Skoda
• Condition: Used
• OEM Part Number: 1Z0971161G
• Substitutable numbers: 1Z0161G, 1Z0 161 G, 1Z0971161G, 1Z0 971 161 G
• Location on the vehicle: Rear, Right
• Part type: Wire Harness
• Category: Wiring Harnesses, Cables & Connectors

Purpose and vehicle placement

The presented wiring harness is dedicated to the rear right door zone in the second-generation Skoda Octavia. It is responsible for routing signals and power between the body modules and components located in the door, such as controls, lighting, or other electrical receivers factory-fitted for this area.

Thanks to its precise fit for the specific mounting location, the cable routing is optimized in terms of length, bending radii, and mounting points, which reduces the risk of insulation abrasion and unwanted stress during door operation.

Construction and technical parameters of the harness

The harness belongs to the Wires, harnesses and connectors group, meaning it has been designed as a complete, ready-to-install solution including wires and factory connectors. The wire cross-sections, insulation type, and connector design are adapted to the current loads and operating conditions in the rear doors, including frequent bending in the area of the grommet between the pillar and the door.

The original design of the harness ensures:

• consistency with the factory electrical diagram of the Skoda Octavia Mk2,
• proper placement of mounting points in the door and on the pillar,
• maintenance of adequate wire length reserve when the door is fully opened,
• compatibility with original body installation connectors.

Performance characteristics and installation

As a component removed from a vehicle, the harness has already had its functionality verified under real operating conditions. It is a practical solution for repairs following mechanical damage to grommets, contact corrosion, or tampering with the installation, where it is necessary to restore the factory cable routing.

Replacing with an original rear right door wiring harness allows you to:

• reduce diagnostic and repair time compared to reconstructing individual wires,
• maintain the factory color scheme and wire numbering, which facilitates future service,
• minimize the risk of installation errors typical of systems built from scratch.

Use in service and diagnostics

The rear right door wiring harness is particularly useful for troubleshooting faults such as intermittent power loss in the door, module communication problems, or mechanical damage to wires in the grommet. Using a complete, original harness allows for restoring circuit continuity without the need for numerous soldered connections or additional service connectors.

For workshops specializing in the Skoda brand, this is a convenient service solution that simplifies the repair process and allows for maintaining consistency with the manufacturer's technical documentation.

Expanding the rear door installation

If you are planning a comprehensive repair or upgrade of the rear right door zone in your Skoda and need other components from the same group, such as additional wire sections, connectors, or complete installation branches, check the available parts in the Skoda wires, harnesses and connectors category.

If you are considering broader use of dismantled components in body repairs and want to better assess their potential in terms of quality and cost-effectiveness, you will find useful information in the article: Replacing body parts with used ones – can dismantled body parts look like new?.